Just wanted to update with a way I just got mine off if anyone else is having issues.
I ran a bolt through one of the holes in the pulley directly behind the fan blade. It binds on the engine block and makes it super easy to break loose.
So you’re wanting to put the bils at 2.8 with the 2” spacer? if I’m understanding right. For that I wouldn’t recommend it. The only reason I can is because my truck sits pretty heavy with my bumper and winch so the bils at 2.8 really only give 1.75-2” of lift over Stock. Unless you have the same...
I’d say it would be pretty close to level with that. However have you measured your truck to figure out how much rake you have? If you’re closer to 3” then you’ll likely need the .5” RC spacer. If you’re closer to 2” then you most likely won’t need it.
Alright guys, update time. So I went back and looked I measurements from before and after my bils at 2.8 and realized I really only had about 1.75-2” of lift out of them. In the rear I had about 1” of lift ( in the rear I had a 2” spacer and TTC-1211s with bils 5100.
So I took everyone’s idea...
That’s some great information and a wonderful resource to check!
I understand there’s no way to increase payload. In Australia you actually can legally but not here in the US. Fun fact.
expedition/overlanding is my main concern for the performance of the truck. That being said you have one...
Sounds good to me! Looks like I’ve got a new game plan.
For the rear, does eibach offer longer shocks then the 1” lift ones I see? I haven’t found much besides them. I’d prefer to not use different shocks front and rear.
I take it the Eibach unit is a full strut assembly? That may be a better choice all the way around. I believe my front bumper as it’s setup weighs approximately 300lbs. I’ll look into that!
@ram1500rsm Interesting points. I looked into their build threads and saw that the open top spacers cause issues over time so I take it the RC spacer doesn't allow that issue to start due to the size of the center opening? I'd definitely want to avoid a preload spacer in that kit but $60 isn't...
What do you think will be over extended what up front? I've looked into the Cargomaxx HD springs for the front but haven't gotten replies back from their customer support. They say a 30% increase in capacity but I want to make sure the actual spring rate is enough of an increase to make a...
Hello everyone!
I have a 2018 ram 1500 4x4. See below for build information. I have a very loaded down ram 1500 and just want to get my height back from heavy setup. But my question is with my Bilstein's at 2.8" do you think a .5" or 1.5" front spacer is acceptable for my situation?
My lower...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.