Nope, jumping pins 3 and 5 will eventually get starter action. Ruled out WIN mod and RF mod. neither consistently have issues, only common denominator is the solenoid on the starter, which will bring a hole new starter into the picture, I'm not changing pieces of a whole and only use new parts.
Noted, that's the next step if it continues to be an issue. Swapped out the starter relay yesterday after the one click, pulled the old relay, jumped pins 3 and 5 in the TIPM, starter turned. Time will tell, thanks for the info.
Ken, I'll get the pin out setting and test it, thanks for the info. (side note) When it fails to start it will do it with both the key and/or remote start feature if that has any bearing on the issue.
2015 Ram 1500 Big Horn 5.7
Intermittent no start, single click, jump out of the cab, seconds later hear another second click from fuse box. Checked relays, reseated them. 12.4 volts at the battery. Changed the battery twice now 1 year apart of each other, no love. When finally fired up have...
Nothing to see really, rubberized electrical taped 2 together, cut to length and cleaned the area, stuffing in down as to not go past the top lip of the box defeating the tight fit. Stays in place, during all driving, washes, etc.
Quick and inexpensive way to stop failing cab vents from leaking water and stop leaves, small branches from going between your rear cab and front box.
Clean all the debris from the flashing at the bottom of your rear cab and front box. It also has the added bonus of limiting or completely...
Yes, it was the master cylinder. Changed it for stock new, flush and bleed the entire system. Dealer had to flush and bleed the ABS portion. Everything was done April 10, 2023. No intermittent issues nor breaking issues. Plungers/seales (internal piston) on the old one were chewed up. Don't put...
2015 Ram 1500 5.7 8 speed Big Horn. Had a fading pedal intermittent, drained fluid, refilled, bleed in sequence, seemed to cure the issue. Few months later noticed master cylinder cap, expansion rubber gasket was popping in like a fluid loss. Fluid levels were spot on, no leaks, etc. Pushed the...
So your saying just hit the - to enter the mode and that's it? it will still disable MDS and not effect the shifting patterns. Needing to do each time you enter back into Drive and nothing further? I always assumed that if you activated it in say, 3rd that it would be the top shift ratio, your...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.