Search results
-
Electrical Question in a gas golf cart
In short: Question is, if I am expecting battery voltage, say 12.6V, to a headlight, but I'm only reading about 6.4V, what is going on? Possible short, or bad ground? How best to narrow down the search for the issue? This is my son's golf cart, and 1st it started blowing the fuse on the...- BadHemi2014
- Thread
- Replies: 7
- Forum: Other Vehicle Discussion
-
A not-so-humble brag
Finally made it to our local dragstrip (Edgewater sports park in Cleves, OH) for test n tune night. Did 5 passes, last and quickest was 14.91 sec @ 93.54 mph. Not too shabby for a 4x4 with A/T tires! Can't wait to go again!- BadHemi2014
- Thread
- Replies: 30
- Forum: General Discussions
-
Anyone have experience with brakes not releasing on a vehicle?
So my 6' foot husband drives a 2013 Beetle. Yeah, laugh, but it's been a great lil car with 30+ mpg. At least until now. We put new pads and rotors on, and it needed both rear calipers. All working fine but pedal was sinking mildly so we had a master cylinder installed (that was in Sept). We...- BadHemi2014
- Thread
- Replies: 2
- Forum: Other Vehicle Discussion
-
Probably dumb caliper change/ brake bleed question
I replaced pads/ rotors all the way around on my Ram (1500, 4wd) and went back in to look at everything due to some brake noise and discovered one piston on front pass side caliper is just a little oozy. So to play it safe I was thinking about replacing all 4 calipers (119k on truck). I've...- BadHemi2014
- Thread
- Replies: 15
- Forum: Tech Info
-
Bolt on muffler for factory single exhaust?
Maybe a dumb question, but everything I see is for factory dual exhaust or for a cat back system. I'd love just a bolt on muffler for my single exhaust, just to liven up the sound. Any suggestions where to start looking? Many thanks!- BadHemi2014
- Thread
- Replies: 4
- Forum: Engine & Performance
-
My P1524 story (or A Reminder of The Importance of a Quality Oil Filter)
Hope this is appropriate to post here as it is primarily an oil filter thread and a reminder as to how picky these Hemi's are! Short story: Leaking K&N filter, tightened it up, oil level ok, next day threw code, oil pressure 28 to 34. Changed oil and filter, problem solved. New filter is RP...- BadHemi2014
- Thread
- Replies: 4
- Forum: Engine & Performance
