-
-
22013ramboy replied to the thread Ideal coolant and oil temps.I read all the filter reviews and it looks like consensus here is the fram xg2 is a good choice. The stock mopar filter is waaay...
-
22013ramboy replied to the thread Service 4wd system.I was thinking same thing, try a cheap replacement and see if it works. I can hear the shift motor when sitting in truck on run but not...
-
22013ramboy replied to the thread Ideal coolant and oil temps.After watching lots of videos from "the motor oil geek" I don't think it's advisable to add additives to good quality synthetic motor...
-
22013ramboy replied to the thread Service 4wd system.That's what I am thinking.
-
22013 ram 1500 5.7 hemi Recently developed and service 4 wheel drive light. I replaced front axle disconnect actuator and looked at and...
-
22013ramboy replied to the thread Loose yello wire.I think it is for right already door ajar. I am goingvtontest it for voltage and trybtonground it just to see what happens. I...
-
22013ramboy replied to the thread Loose yello wire.Yes I Do have remote start on build sheet and it works fine. I am pretty sure that I need to trace down a shorted or broken wire for 4wd...
-
22013ramboy replied to the thread Loose yello wire.Ok I thinkni figured out the loose yellow wire. Pin #5 right rear door ajar switch. I had that error , thenninused alfa obd to...
-
22013ramboy replied to the thread Loose yello wire.C1464 front axle disconnect control circuit low
-
22013ramboy replied to the thread Loose yello wire.Here is the loose yellow wire. It comes off a small bundle paired with just the purple wire. I did clean all.connectors and found thus...
-
-
22013ramboy replied to the thread Loose yello wire.That's the only can bus error. The service four wheel drive does not report an error. I checka all connectors to transmission, front...
-
22013ramboy replied to the thread Loose yello wire.Ok pics today. Inhave the backup camera that displays on the uconnect screen. So if that yellow wire is for rear view mirror. Good. But...
-
22013ramboy replied to the thread Loose yello wire.I am pretty sure the loose wire is the yellow wire on pinout 26. It's says can c - I was able to disconnect harness fro. Bcm, but cable...
-
-
22013ramboy replied to the thread Loose yello wire.Thanks yes i hate auto correct. No park assist. The purple wire defintleey connects to bcm, the yellow one looks like it should be...
-
-
Loading…
-
Loading…
Members online
- RedHeadYeti
- u2slow
- aepowell
- TRK_GANG74
- David James
- yogibear18
- NickD
- eefee
- bigdog85
- BIGORANGERAM90
- Black1500Ram
- MaximumSteel18
- saturnx
- Michael56
- jabartram
- 13RAM13
- 2018power wagon
- Marshall
- GrandpaBob
- Hagar1
- El_Dude
- Dean2
- 06 Dodge
- Latemodel55
- RamMnWild
- Jas34
- Curmudgeon
- Lizzycalgal
- Brentzwro
- rvroverr
- DanHate
- ButtKiss
- kirk35
- Buddy
- Lance1985
- Onefastduc
- ithurtz
- Janelle
- Jeepwalker
- Sean J Blackburn
- Moneebabs
- bankshot
- ffeschjeff
- Nick@GotExhaust
- AZ MARK
- Gregket1
- Flip-er
- StateOfMind
- Ponyboy
- ramnododge