Recent content by Daw14
-
D
Side exit exhaust / new muffler
You could get a two into one ,or two in two out muffler. There are lots of options out there nowadays. I prefer magnaflow, I have one on my truck ,it’s ten years old and is still solid . I like the sound and highly recommend.- Daw14
- Post #7
- Forum: Engine & Performance
-
D
Engine stand
This ^^^^^ , finish removing the flywheel and torque converter. That will make it closer.- Daw14
- Post #3
- Forum: General Discussions
-
D
OEM Manifolds done with fixing this crap
Take a pair of those spares and put a belt sander to them , or have them milled flat. They are done warping now with so many heat cycles. Another set of mopar bolts and studs should be the end of this issue.- Daw14
- Post #2
- Forum: Engine & Performance
-
D
WHAT THIS PART. 1988 5.2L
Get a cheap Boroscope camera , it can get in there to get some photos.- Daw14
- Post #13
- Forum: General Discussions
-
D
Whats your usual voltage. Hemi etorque
Those look normal , all the way .- Daw14
- Post #4
- Forum: General Discussions
-
D
Engines compatible?
It’s here. I have no answer for you , someone who does should be along shortly.- Daw14
- Post #3
- Forum: Engine & Performance
-
D
OEM Hemi Exhaust on the V6
I would guess manifold back to include the catylitic converters .- Daw14
- Post #4
- Forum: V6 Engine & Performance
-
D
AGM Battery for sub/amp
I’ve been running a AGM for a couple of years now with no issues, but no large system.- Daw14
- Post #2
- Forum: Audio & Electronics
-
D
3” Rear Coil Springs?
White lithium in a spray can will stay attached pretty well ,it lasts longer than most other lubes . -
D
2012 Ram 1500 5.7 No Power
I would locate and clean whatever grounds you can .not sure if there’s fuses at the terminals, but ?- Daw14
- Post #11
- Forum: General Discussions
-
D
2014 Ram 1500 5.7 a/c cuts off occasionally
Try to find an independent shop , it’s a fan issue , a dealer will take a lot more of your money . An independent shop should be more reasonable.- Daw14
- Post #6
- Forum: General Discussions
-
D
Lowering rear and getting a better ride.
A 4’ x 6’ by 1/2 inch steel plate bolted to the bed floor should be just about 500 pounds . That should improve the ride and give a bit more traction .- Daw14
- Post #5
- Forum: Heavy Duty
-
D
2009 Ram 1500 5.7 MDS - weird #5 misfire problem
Lots of counterfeit plugs out there lately .- Daw14
- Post #19
- Forum: Engine & Performance
