ezmoney's latest activity
-
ezmoney reacted to Wild one's post in the thread 5.7 with 6.4 cam and intake makes no bottom end with
Like.
It's the cam,the 6.4 intake will make more torque down low,in comparision to the 5.7 intake,as it has longer intake runners,but the 5.7... -
ezmoney replied to the thread 5.7 with 6.4 cam and intake makes no bottom end.If I get the 6.4 intake from Moe's and put it on my 5.7 will I lose bottom end power like op did, or is it the cam that is causing his...
-
ezmoney replied to the thread Big ****** grin 392 swap.That thing is going to do big burn outs all the way down the street!
-
I first decided that I wanted to lower the rear about 2" to level it. I didn't want to take too much off so I started by cutting 1.5...
-
-
ezmoney replied to the thread Belltech bump stops.Do you have a link? Are they available online?
-
ezmoney replied to the thread Belltech bump stops.Sounds like if there were problems with the Inez no cut kit, it's likely this Trekline kit may have problems also. I am interested in...
-
ezmoney replied to the thread Belltech bump stops.No cut kit. The description says 1"-4" drop only, will not work for 5"+ drops. I didn't measure mine but I think it's about 4.5" or...
-
ezmoney replied to the thread Belltech bump stops.Trekline motorsports sells no cut brackets. Are they no good?
-
They don't sell the no cuts anymore. The holes you drill are the same. With the cut brackets, you have to cut off the upper control...
-
The brackets work, the enhanced control arms from core, or freedom and others will mask most of the symptoms. The big advantage of the...
-
ezmoney replied to the thread Belltech bump stops.Ok, I will get the brackets. If I get the cut brackets, does that mean I drill less holes, as I would with the no cut brackets? What's...
-
Myself I do full lock upshifts from 3rd gear up, reduce timers, reduce slip values, reduce clutch slip time, increase pressure(how much...
-
With any tuning, especially transmission tuning, it's so subjective to personal preferences and likes, a person can't really say do this...
-
ezmoney replied to the thread Belltech bump stops.Thanks for the advice. I may get the relocation brackets. I think that I read in another thread that you recommend the brackets instead...
-
Long story short lifter failure 146k OK, I guess I have teased you guys long enough. It’s finally happening. Got the whole front off. y...
