Lots of "lost communication" codes, Battery? PCM/ECM? Something Else?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

jimbono

Junior Member
Joined
Apr 14, 2024
Posts
1
Reaction score
0
Location
hawaii
Ram Year
2013
Engine
4.7
Lots of "lost communication" codes, Battery? PCM/ECM? Something Else?



My 2013 1500 tradesman with the 4.7 just started throwing a bunch of communication codes (at the bottom of this post). The dash gauges will turn on and off (speedo/tach/etc) and the display flickers as well. Occasionally "no bus" shows up on the screen as it boots up/shuts down. A bunch of warning lights pop up but the truck is running smoothly.


I initially checked my battery voltage at 12.35 volts, hooked up to a charger and now its at 12.5/12.6 or so. Battery is almost 2 yrs old. I cleaned the terminals (they looked clean already), inspected/cleaned the frame grounding point by the battery, unplugged and plugged back in the connectors under the steering wheel by the pedals and also the ones in the BCM. I pushed in all the fuses in fuse box and checked them for continuity.

Before I did any of that work, the codes included a lot of modules. After doing the stuff above, the codes are mainly limited to ABS/Traction control. They popped up even after a fresh charge and after a minute or two of running time. Do these look like my battery is going bad and causing havoc? Alternator? PCM? I'm inclined to think that with so many different modules there's a power supply issue or something like that. How would I know if my alternator were going bad?



Truck has had zero issues at all for 141,000 miles. I had it parked at a friends house for 5 days while I travelled, and it started throwing the codes when they were on the way to the airport to pick me up.



Here is a quick clip of the dash, but this is after the reset and the only persistent caution light is the traction control. Before I did anything above, the check engine light, traction control, and TPMS all stayed on. (TPMS readings were still visible on the computer though): https://youtu.be/t5xTCWj-XW4



Codes:



After the battery charge/cleaning/unplugging/etc (what's currently popping up on my scanner):

U1120 Lost Wheel Distance Message

U0002-00 Can C Bus Off Performance: No Sub Type Information

B16B7-15 Center Stop Lamp Control Circuit: Circuit Short To Battery or Open



U0140-00 Lost Communication With Body Control Module: No Sub Type Information

U0121-00 Lost Communication With Anti-Lock Brake System (ABS) Control Module "A": No Sub Type Information



C1501-96 Tire Pressure Sensor 1 Internal: Component Internal Failure

C1580-00 Left/Right Side Tire Pressure Sensor Location Undetermined: No Sub Type Information

C1581-00 Front/Rear Tire Pressure Sensor Location Undetermined: No Sub Type Information

C1504-96 Tire Pressure Sensor 4 Internal: Component Internal Failure



U0212-00 Lost Communication With SCM: No Sub Type Information

U0002-88 Can C Bus Off Performance: Bus off

U0126-00 Lost Communication With Steering Angle Sensor: No Sub Type Information



note: the TPMS readings just starting showing blank - they were all fine before I did any work, not sure if they just need to relearn since I haven't driven fast/far enough yet.



Before I did anything:

U0001 CAN C Bus

U1110 Lost Vehicle Speed Message

U1120 Lost Wheel Distance Message

U0212 Lost Communication With SCM

U1120 Lost Wheel Distance Message

U0002-00 Can C Bus Off Performance: No Sub Type Information

B16B7-15 Center Stop Lamp Control Circuit: Circuit Short To Battery or Open



U0001-00 CAN C Bus: No Sub Type Information

U0121-00 Lost Communication With Anti-Lock Brake System (ABS) Control Module "A": No Sub Type Information

U0127-00 Lost Communication With Tire Pressure Monitor Module: No Sub Type Information

U0100-00 Lost Communication With ECM/PCM: No Sub Type Information

U0140-00 Lost Communication With Body Control Module: No Sub Type Information

U11E8-00 Lost Communication with EPS Steering Torque Message: No Sub Type Information

U0212-00 Lost Communication With SCM: No Sub Type Information

U11B9-00 Lost Communication with RF Hub: No Sub Type Information



C1501-96 Tire Pressure Sensor 1 Internal: Component Internal Failure

C1580-00Left/Right Side Tire Pressure Sensor Location Undetermined: No Sub Type Information

C1581-00 Front/Rear Tire Pressure Sensor Location Undetermined: No Sub Type Information

C1504-96 Tire Pressure Sensor 4 Internal: Component Internal Failure

U0002-88 Can C Bus Off Performance: Bus off

U0126-00 Lost Communication With Steering Angle Sensor: No Sub Type Information

C2129-16 Battery Voltage: Circuit Voltage Below Threshold

U0415-00 Invalid Data Received from Anti-Lock Brake System (ABS) Control Module "A": No Sub Type Information

C2128-00 ECU Reset/Recovery Occurred: No Sub Type Information



U1141 Lost Brake and Torque Messages

U11BC Lost Brake Switch Message

U0212 Lost Communication With SCM

U113E Lost Communication With Intelligent Battery Sensor

U1110 Lost Vehicle Speed Message

U1120 Lost Wheel Distance Message

U0001 CAN C Bus
 

Black-Wolf

Senior Member
Supporting Member
Military
Joined
Nov 21, 2018
Posts
264
Reaction score
307
Location
North Carolina
Ram Year
2017
Engine
Hemi 5.7
Sounds like a bad CAN Buss or bad CAN Buss Star Connector. There are several, and they act as a communications bridge between the various computer modules in your truck.

1713207781482.png1713207807447.png
 

Latest posts

Forum statistics

Threads
196,013
Posts
2,876,816
Members
157,016
Latest member
professionalish
Top