Search results
-
Window trim
hey all, i'm bumping this. I have a 2014 crew and my trim looks like garbage as well. Looking to replace it all. I assume the best solution is to individually buy these still??? I am finding some aftermarket sets on ebay, but not sure I want to go that route. Can't believe each piece is $50 - $100.- billygg420
- Post #10
- Forum: All Mopar Parts
-
2014 5.7 8 speed trans flush - couldn't get pan out
I definitely got all 3 nuts. You jacked it up using the transfer case? My truck isn't 4 wheel, I don't think I have one of those. I have the 2 piece drive shaft- billygg420
- Post #4
- Forum: General Discussions
-
PPE Pan Install Issue
Hey Guys, Nice write up here. I am in the middle of tackling this and had an issue. couldn't get the pan out. I have a 14 with the crossover and the pan is stuck on the pipe. I attempted to jack up the trans, but it wouldn't budge??? I took the 3 cross-member bolts to trans mount out. Used a...- billygg420
- Post #11
- Forum: Engine & Performance
-
2014 5.7 8 speed trans flush - couldn't get pan out
Hey All. I know there's quite a few threads on the proper procedure for flushing the zf 8 speed. I read and printed some of them out. I tackled this job last week and it didn't go as planned, go figure. I have the 8 speed trans where the crossover exhaust pipe exists. Because of that, I...- billygg420
- Thread
- Replies: 5
- Forum: General Discussions
-
2014 2 Piece Drive Shaft Lubrication
Anyone have any suggestions on this?- billygg420
- Post #2
- Forum: Exterior
-
2014 2 Piece Drive Shaft Lubrication
Guys, There's been several posts about lubricating the spines in the 2 piece drive shaft to stop the weird thump on take off. I'd like a little assistance on this if possible. I have the thump, took it to the stealership under warrantee, they decided it was the shaft, replaced it, thump went...- billygg420
- Thread
- Replies: 3
- Forum: Exterior
