Search results

  1. HarrisFD

    2018 2500 6.7 forcing ReGen(de-Soot) with AlphaOBD and monitoring with Torque Pro

    My 2015 gave same message but it ran the stationary desoot for about an hour. Didn’t clear the 5 mph derate message tho. Still stuck at 132 miles before I can’t go anywhere. Ran the scr performance test, still took an hour and then it said status not available at the end. Derate message came...
  2. HarrisFD

    Heated Seat Elements

    Thanks, I shop fleabay all the time. That wasn’t the actual question. Let me rephrase: Has anyone had success wiring aftermarket heaters to factory seat controller?
  3. HarrisFD

    Heated wheel roadblock

    Never mind, I figured it out.
  4. HarrisFD

    Heated wheel roadblock

    I’ve been doing a major gut and redo of my rams interior. One of the upgrades I’m currently in the middle of is a heated wheel upgrade. I’ve hit a roadblock in that I don’t know where to connect the two pins from the conversion harness into the back of the I-311 connector above the drivers...
  5. HarrisFD

    Heated Seat Elements

    So I finally got around to upgrading my seats on my 2015 Ram. Going with power seat frames and Katzkin covers. The elements in my donor seats had already been pirated and I was wondering if there are any replacement seat heaters that don’t cost $300+ each. I’ve already invested in the conversion...
  6. HarrisFD

    SOLD - Console Safe for 2012 - 2018 RAM 1500, 2500, 3500

    Pm sent
  7. HarrisFD

    Wanted Gen 4 OEM Led Tail-light Harness

    Anyone know where to get these pigtails for a 13 and later factory LED Tail light?
  8. HarrisFD

    LED taillight pigtails/harness

    I’m in same boat, are you selling the adapter harness? If not do you have a parts list so we can make our own? I too want to convert from halogens to oem led’s and change settings in Alfa obd. The resistor thing seems like a fire looking for a place to happen.
  9. HarrisFD

    Hi Beam Circuit tie-in

    Good info, so a buck fifty diode and a couple solder joints would be cheap insurance. Any thoughts on diode values and placement in circuit? Thanks for info.
  10. HarrisFD

    Hi Beam Circuit tie-in

    Thanks for the insight, while I could eliminate the switch I’d like to have the option of disabling the 520’s when there’s other traffic around. Normally the dot 520’s are 55w, these are nearly double. They are not street legal and I’d have to switch to low beams pretty early if I have oncoming...
  11. HarrisFD

    Hi Beam Circuit tie-in

    2015, Why Under hood and not under dash? Will computer wig out? Relay Trigger is a pretty small draw.
  12. HarrisFD

    Hi Beam Circuit tie-in

    So I’m in the process of making my 2015 2500 more deer proof. I just installed a Trailready pre-runner bumper and PIAA Fogs and 100w driving lights. The fogs I wired to plug into stock harness, but the drivers are wired into a relay. I want to trigger the driving light relay off the hi beams and...
  13. HarrisFD

    Intercooler duct retainers

    Not worth searching for hours on end. The Napa retainers work fine, new Intercooler is back on truck.
  14. HarrisFD

    Intercooler duct retainers

    Checked local dealer, they have no clue what part# is, and it does not appear that they come with the flat shroud piece (aka "seal"). Napa doesn't have an exact replacement but Balkamp 665-1000 will work.
  15. HarrisFD

    Intercooler duct retainers

    Hi I’m in the process of fixing my 2015 6.7 4x4 from the last deer strike and I have run into small roadblock. I’m trying to find the plastic retainers that hold the flat plastic duct to the top of the Intercooler ( aka “seal”). Apparently they come with the new duct but are not listed...
  16. HarrisFD

    Help! Lost WIF sensor connector seal.

    Awesome thanks.
  17. HarrisFD

    Help! Lost WIF sensor connector seal.

    I recently changed out the Fuel filters on my 2500 6.7 Cummins and later I found a little oval yellow wire connector seal on the driveway. I saved it, figured I’d put it back in later. Well time went by and I now I can’t find the stupid little seal. It goes in the female connector that clips to...
  18. HarrisFD

    Totaled??

    You’d be amazed at what they will total a vehicle for these days. I bought my 2015 Cummins 4x4 off of auction. It was “totaled” after rear-ending a Jag. Cost a grand total of $1400 to fix: bumper, intercooler , grille. Frame was untouched, minor 2” dent in front of hood. I’d say they’re going to...
  19. HarrisFD

    Yukon Limited Slip or AAM Helical or Eaton Helical?

    K thanks, one of the potential issues I see is that if you have a 4th gen ram with AAM 11.5, Eaton website says you have to swap to earlier ring and pinion to run the Truetrac. Guess I’ll call their tech line to confirm or see if there is a newer part number.
  20. HarrisFD

    Yukon Limited Slip or AAM Helical or Eaton Helical?

    Did you put it in a 4th gen? Did u have to change to earlier ring & pinion?
  21. HarrisFD

    Yukon Limited Slip or AAM Helical or Eaton Helical?

  22. HarrisFD

    Yukon Limited Slip or AAM Helical or Eaton Helical?

    Thanks everyone for the feedback, looks like helical is the winner. So now another twist: is Factory AAM or EATON Truetrac the better helical unit? I see on EATON’s website they say that you must use 03-07 gear set for later year 11.5s? Anybody successfully done an Eaton in a 4th gen? Not...
  23. HarrisFD

    Yukon Limited Slip or AAM Helical or Eaton Helical?

    Posted on another thread and got crickets so I'm trying the direct approach. I recently moved to Utah and snow is a common occurrence where I now live. On snow days, the traction control is pretty much useless on even the slightest grade on my 2500 and I have to use 4WD to get out of my...
  24. HarrisFD

    "Limited Slip" vs "Anti-Spin Differential Rear Axle"

    I realize this thread is a few months old but I have a similar question. I recently moved to Utah ( from San Diego LoL) and snow is a common occurrence where I now live. On snow days, the traction control is pretty much useless on even the slightest grade and I have to use 4WD to get out of my...

Latest posts

Members online

... and 94 more.
Total: 2,035 (members: 144, guests: 1,891)
Robots: 1,368

Forum statistics

Threads
196,226
Posts
2,879,395
Members
157,396
Latest member
Trent5107

Share this page

Top