Recent content by jeovanicorro

  1. J

    Truck won’t start when engine is hot only when is cooled down 4.7

    it was my injectors the chinese aftermarket ones bad quality i put my oem ones back on and worked fine
  2. J

    Truck won’t start when engine is hot only when is cooled down 4.7

    swapped the battery out and still doing the same thing also replaced my terminals i’m thinking the injectors i have are bad there not oem because the truck would start fine if i pour gas into the tb it starts back up and drives normal
  3. J

    Truck won’t start when engine is hot only when is cooled down 4.7

    i have the battery under warranty! so i’m heading tomorrow to my local autozone and getting it replaced it’s an AGM 65 that’s the size of the third gen rams
  4. J

    Truck won’t start when engine is hot only when is cooled down 4.7

    02 4.7 ram engine just got rebuilt and truck turns on and runs fine until i turn it off after its been at operating temperature if i let it sit for like 5 minutes and try cranking it it only spins i haven to let it cooldown and it starts back up without any problem i swapped out the fuel pump...
  5. J

    4.7 oil pressure sensor

    i was thinking fuel pump i have it under warranty so im thinking of swapping it out i replaced it last year in august but truck sat ever since and was only moved less than 100 miles
  6. J

    4.7 oil pressure sensor

    swapped it and so far it works good now my only problem now is that when it gets warm and i turn off the truck it won’t start back up engine just spins and only way it turns on is if i let it cool down or if i pour some gas or starting fluid onto the throttle body
  7. J

    4.7 oil pressure sensor

    what was wrong with your 2006 the problem you had?
  8. J

    4.7 oil pressure sensor

    ok sound good getting oil pressure right now
  9. J

    4.7 oil pressure sensor

    also thinking of replacing sensor like you said
  10. J

    4.7 oil pressure sensor

    forgot to mention engine got rebuilt new pistons new rod bearings same oil pump new rings heads resurfaced and all new gaskets all around pick up tube wasn’t clogged neither my mistake was not swapping the oil pump which i think was the bad one i was playing on running 10w-30 or 10w-40 can i get...
  11. J

    4.7 oil pressure sensor

    only does it when warmed up at idle
  12. J

    4.7 oil pressure sensor

    when warmed up it drops oil pressure on the gauge and the check gauges light pops up i’m tryna figure out around what psi would the gauge go down and the pop up light comes up i read 4psi is the minimum oil pressure at idle on the 4.7 correct me if im wrong
  13. J

    4.7 oil pressure sensor

    does anyone know how the 4.7 oil pressure sensor gauge works on the jtec engine 02-03 if i’m not mistaken i had read on another post that the gauge would drop all the way down if pressure went don’t by a little it won’t work like the 5.7 where the gauge comes down a little and shows accurate...
  14. J

    4.7 code p0354

    took the tape off the harness and moved it around and it’s good now
  15. J

    4.7 code p0354

    getting this code and it burnt my coil pack already anyone have any idea what it could be i was thinking a short in the wire
See more

Latest posts

Members online

Total: 446 (members: 17, guests: 429)
Robots: 1,057

Forum statistics

Threads
196,249
Posts
2,879,697
Members
157,431
Latest member
Mopar big state 1

Share this page

Top