Search results

  1. 16WhiteQC

    Hard Top Folding Tonneau Cover Repair

    I had to do this on my Back Flip MX4. I used automotive 2 sided molding tape and expanding rivets. Make sure to not drill through the top side!!!! The rivets will pull themselves in and open (I used the 9/16" once i think), all my rails are now stronger than when the cover was new...
  2. 16WhiteQC

    OEM Manifolds done with fixing this crap

    https://us.bddiesel.com/products/exhaust-manifold-kit-dodge-ram-5-7l-hemi-1500-2500-3500-2009-2022?variant=41740061442231 These or LT headers and be done !
  3. 16WhiteQC

    0-60 times for everyone

    You replied to a comment from 2020...
  4. 16WhiteQC

    35w or 55w HIDS

    I did the full Mori kit including the Mopar harness. No issues other than a relay over the past 5+ years https://www.theretrofitsource.com/2015-mopar-morimoto-elite-HS-15MOPAR?quantity=1
  5. 16WhiteQC

    35w or 55w HIDS

    Not true, I ran the mori 55w kit for years in stock projectors, loved them! I had my light retrofit with D2S 5.0's and went with new 35 kits (age on the old ones) and honestly was not blown away with the output. Swapped back to the 55's and wow, there is the output I was used too! Swapped...
  6. 16WhiteQC

    Rear Shocks Upside down on the 4th gens

    My fox are in body up, I called fox and this is how they said to run them. I do have a nick or 2 on the rod from rocks but no leaks and they have been on for 5+ years
  7. 16WhiteQC

    Time to Un-lift my truck

    Stock height and extra load capacity when needed. https://www.ramforum.com/threads/tuftruck-ttc-1223v-rear-springs-installed.161639/ Should be exactly what you are looking for.
  8. 16WhiteQC

    HID Ballast in Cold Weather

    Yes, my Morimotos do this, before you blame the ballast/ignitor check your relays. I swapped the relay from one bank to the other and the problem followed, replaced the relay's and all good...that was 2 years ago and mine is doing it again...the Morimoto relays don't like the cold it seems.
  9. 16WhiteQC

    RamForum Exhaust 4th Gen Clips and Vids

    16' Ram 1500, ARH 1 3/4" LT's and cats, Borla Touring catback. Cold start @ 30*, now has 1500 miles on it, got a little louder but still VERY tame compared to the Corsa. https://www.youtube.com/shorts/xcEzsQD9l08
  10. 16WhiteQC

    5.7 Intake manifold leaking oil, upgrade to 6.4?

    It is leaking from the seem higher up on the intake, not from below it as far s I can tell. (was wet up high) I mentioned the S&B intake in my original post... You replied that the 6.4 swap has been covered in many threads already... I then replied that I don't recall anyone mentioning using...
  11. 16WhiteQC

    ARH 1 3/4" LT's w/cats installed - What a royal PITA!

    The truck sounded good at start and part throttle other than being loud with Corsa. Mid to WOT it got very raspy/rattly sounding and VERY loud. I have since swapped to Borla touring, info on that here -...
  12. 16WhiteQC

    Ran a 22' Durango R/T town and go Mopar edition - was dead even!

    Mods are in my sig. Was blown away that my friend and I were literally neck and neck from a roll. Could not pull on him at all to 100! From a dig it was pointless, all I did was spin, hard, with the LT's now vs his AWD. Literally spun through the Intersection and he put 2 cars on me and stayed...
  13. 16WhiteQC

    5.7 Intake manifold leaking oil, upgrade to 6.4?

    Bolts were loose, but my leak is the seam, there where it's wet from the looks of it after degreasing everything. Leaks down the back of the head to the block/bell housing and down.
  14. 16WhiteQC

    5.7 Intake manifold leaking oil, upgrade to 6.4?

    I have read the threads, don't recall seeing anything about the S&B 6.4 intake fitting the 1500 with the 6.4 manifold swap. I'll buy the harness vs cutting and extending wires, it's worth the cost to me.
  15. 16WhiteQC

    5.7 Intake manifold leaking oil, upgrade to 6.4?

    So my factory intake manifold is leaking oil at the seem by the pcv (63,000 miles). A new OE 5.7 manifold is not cheap when compared to doing the 6.4 swap. Looking into the 6.4 swap I will need the following: Would do the MMX kit with harness - I think I need to source and EGR plate now...
  16. 16WhiteQC

    I swapped Corsa for Borla Touring now that I have LT's, here is my take.

    Another update as the exhaust breaks in. Cold starts have gotten a little louder, very deep tone that can clearly be heard from inside the house for the first 30 sec. or so. Still not as loud as the Corsa was by any means. Drone - very subjective as stated previously and honestly is not really...
  17. 16WhiteQC

    Wondering what would be the best tires in snow/all terrain for stock 20 inch rims?

    KO2's or Wildpeaks for an AT tire, as long as you know for to drive a 4wd in the snow they work great. If you have to be out in the snow, all the time and have lots of ice get dedicated snows.
  18. 16WhiteQC

    I swapped Corsa for Borla Touring now that I have LT's, here is my take.

    Little update now that I have 300+ miles on the Borla. Yes, it does have mild drone at 1500rpm, not as bad as other systems I have had but it is there. The exhaust does have more exhaust sound in the cab than the corsa but it is not invasive. The Borla is still breaking in and the sound is...
  19. 16WhiteQC

    I swapped Corsa for Borla Touring now that I have LT's, here is my take.

    Forgot to attached pictures if anyone wanted to see how the Corsa and Borla looked next to each other. Corsa had been on the truck for a few years, in the snow belt. Held up great, little wire wheel and it should look newish. Borla measured 24" on the muffler FWIW
  20. 16WhiteQC

    RamForum Exhaust 4th Gen Clips and Vids

    16' Ram 1500, ARH 1 3/4" LT's and cats, Borla Touring catback. Cold start @ 45*, literally the first start with no miles on it, way tamer! https://www.youtube.com/shorts/tvk4EcX_O0c
  21. 16WhiteQC

    I swapped Corsa for Borla Touring now that I have LT's, here is my take.

    I have been running the Corsa catback for a few years now and have always been happy with it. I did miss the low tone burble and sound of the 18" mufflex I ran but not the drone. There is no drone with the Corsa, none, ever! Well, I recently installed ARH 1 3/4" LT's with cats...and well...the...
  22. 16WhiteQC

    Bashed in Rear Bumper 2014 Ram 1500

    Got "bumped" at a stop sign 2 weeks back...$2,000 to repair... (New bumper, pad, brackets) If the bracket(s) bent the bumper is probable tweaked as well, FYI
  23. 16WhiteQC

    Is a stage 1 cam worth it on my 15’ Express 5.7?

    Go on ebay and get a used PCM with the correct part # for your truck, send that one out to be unlocked (this is what I did). Them pic a tuner / software (diablo vs. HP), Hemi Fever, Jay Greene, Flyin Ryan, etc. 2 of these guy have cams available that I know of. To get the most our of a cam...
Top