MudDog2007
Member
somebody can tell me why the truck randomly when put in drive will go straight to 4th. Jump out and disconnect batt for a min and reconnect . Back to normal.
2010 Ram SLT 5.7 545RLE 180,000 miles
Things I have done to try and correct this.
1. 6/23 Replaced solenoid module (Mopar brand)/trans filters/10 quarts of ATF4 seemed to help but
2 . Sent ECM off and had it cleared due to a software issue and reloaded factory SW. No change
3. Replaced TIPM with a Mopar Reman unit. If anything it got somewhat worse.
4. Battery and connectors replaced. No change.
To re-iterate this only happens after a start. Warm or cold. The occurance is random. Batt disconnect for a min then reconnect clears the issue. Code that pops up is P0883$07E8 TCM power input signal high.
2010 Ram SLT 5.7 545RLE 180,000 miles
Things I have done to try and correct this.
1. 6/23 Replaced solenoid module (Mopar brand)/trans filters/10 quarts of ATF4 seemed to help but
2 . Sent ECM off and had it cleared due to a software issue and reloaded factory SW. No change
3. Replaced TIPM with a Mopar Reman unit. If anything it got somewhat worse.
4. Battery and connectors replaced. No change.
To re-iterate this only happens after a start. Warm or cold. The occurance is random. Batt disconnect for a min then reconnect clears the issue. Code that pops up is P0883$07E8 TCM power input signal high.
