I lowered mine 2"up front and 4"rear with Belltech springs and no relocation brackets on the rear for a good 2 years. They wheels being off center was annoying.
Recently went another 2" all around with IHC control arms. Did the brackets in the rear. Leveled out the rear trailing arms and...
I bought the kit and read the instructions but haven yet to install it. The arm fabrication is great. Their engineering here is pretty hack. They used GM ball joints I'm guessing because they are the right taper and bolt in. But the top is way to long and the bottom is too short.
Look at the...
I have been running BellTech 2/4 springs for about 1.5 years. No rubbing. I would think the drop spindles would be even worse as they push the wheels out an other inch.
IHC control arms bring in the wheels .75 in so might be better but would have to go 3/5.
I know its been discussed here but never saw many conclusions for lower ball joints for us 2wd without air suspension guys. No place lists them specifically for this application. But I just installed some last week. Figured I would share the 4wd ball joints are the same. I ended up using these...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.