EdGs
Senior Member
Continuing my brake noise saga, I pulled my drivers rear axle seal and bearing, and here I am so far:
After pulling, I noticed some roughness in the bearing bore:
Bottom:
Top:
I cannot afford a new rear end, hope I can clean it up with some fine emery cloth. Top of OE bearing:
I don't have much choice at the present except to clean it up and install new bearings and seals, and hope for the best.
Thoughts?
After pulling, I noticed some roughness in the bearing bore:
Bottom:
Top:
I cannot afford a new rear end, hope I can clean it up with some fine emery cloth. Top of OE bearing:
I don't have much choice at the present except to clean it up and install new bearings and seals, and hope for the best.
Thoughts?
Last edited: